Disk-on-disk and Ball-on-disk Friction and Wear Testing
The torque converter is directly connected to the turntable on which the test piece can be mounted.
For the loading, it will be possible to select the disk for surface contact and the ball indenter for point contact.
Because the disk and the ball indenter can both be balanced using the dead weight, low loading can be used to carry out highly accurate friction and wear testing.
Because the maximum rotation is 3000rpm, high speed wear testing can be carried out.
This is most appropriate for carrying out high speed wear testing in only one direction.
Since the torque converter is directly connected to the turntable, even minute changes in friction can be detected.
As a similar balance arm mechanism is utilized to the one in the Surface Property Tester Type: 14FW, it will be possible to use various types of measurement probes, including those for surface, point and line contact.
In addition, the vertical loading can be set in 10g steps.
10-3000rpm (Maximum 9,999,999 times rotation counter, with digital rotation meter)
Brushless Motor
0-4000g/cm
φ5inch
Brushless Motor
Overloading safety equipment
High Frequency Noise Countermeasure Circuit
Zero Point Adjustment: Digital Servo Auto Zero Reset Method
Output (Non-linear): +/-5V (+/-0.05% FS or less)
Sensitivity Switching: 0, 100, 50, 25, 10% FS
SN Ratio: 60dB (Maximum Sensitivity)
Response Frequency Characteristics: 2kHz/-3dB
Filter: 1, 10, 100Hz, Pass (Low Pass Filter)
(Dynamic Strain Amplifier is incorporated in the main unit.)
0-50℃ RH 85% or less, non-condensing
AC100V 50/60Hz
Main Unit: W630mm x D350mm x H435mm
